New Self-Stretching Material Developed -- COMPAMED Trade Fair

New Self-Stretching Material Developed

Graphic: A double arrow printed on wrinkled paper

A new polymer assumes its programmed shape and returns to its initial state with no noticeable deviation even after multiple cycles; © robodread

Although most materials slightly expand when heated, there is a new class of rubber-like material that not only self-stretches upon cooling; it reverts back to its original shape when heated, all without physical manipulation.

The findings were recently published in the journal ACS Macro Letters.

The material is like a shape-memory polymer because it can be switched between two different shapes. "However, unlike other shape-memory polymers, the material does not need to be programmed each cycle - it repeatedly switches shapes, with no external forces, simply upon cooling and heating," said Mitchell Anthamatten, an associate professor of chemical engineering.

Anthamatten and his team built on the success of a recently developed polymer that can also stretch when cooled. The other polymers need to have small loads - or weights - attached in order to direct the shape to be taken. That is not the case with the Rochester polymer, because Anthamatten’s team "tricked it into thinking" a load was attached.

To carry out their strategy, the researchers introduced permanent stress inside the material. They began with polymer strands that were loosely connected by bonds called crosslinks that create a network of molecules. The material was stretched with a load attached to give it the desired shape. At that point, they added more crosslinks and cooled the polymer, causing crystallization to occur along a preferred direction.

Anthamatten’s team showed that internal crystallization forces are strong enough to stretch the material along one direction. Once cooled below about 50°C, polymer chain segments pack into highly ordered micro-layers called lamellae. This reorganization occurs within a network of polymer chains, causing the material’s length to increase by over 15 percent.

"The stress we built into the network takes the place of the load and enables the material to 'remember' the shape it will assume when it is later cooled without a load," said Anthamatten.

Conventional shape-memory polymers need to be reprogrammed after each cycle, but that is not the case with the material developed by Anthamatten and his team. After multiple cycles of cooling and heating, they found that the material assumed its programmed shape and returned to its initial state with no noticeable deviation.

Anthamatten envisions the material being applied to a number of areas in which reversible shape-changes are needed during operations, including biotechnology, artificial muscles, and robotics.

"The next step is to optimize the shape of the polymer material and the energy released during the process," said Anthamatten. "That will be done by adjusting the type and density of crosslinks that tie the individual chains together."; Source: Rice University