These electron microscope images
show examples of a new technique
developed at Princeton University
for perfecting nanometer-scale
They use a process that could dramatically improve chip quality without increasing fabrication cost.
The method enables more precise shaping of microchip components than what is possible with current technology. More precise component shapes could help manufacturers build smaller and better microchips, the key to more powerful computers and other devices.
Microchips work best when the structures fabricated on them are straight, thin and tall. Rough edges and other defects can degrade or even ruin chip performance in most applications.
Chou's method, termed Self-Perfection by Liquefaction (SPEL), achieves by melting the structures on a chip momentarily, and guiding the resulting flow of liquid so that it re-solidifies into the desired shapes. This is possible because natural forces acting on the molten structures, such as surface tension -- the force that allows some insects to walk on water -- smooth the structures into geometrically more accurate shapes. Lines, for instance, become straighter, and dots become rounder.
Simple melting by direct heating has previously been shown to smooth out the defects in plastic structures. This process can't be applied to a microchip, for two reasons. First, the key structures on a chip are not made of plastic, which melts at temperatures close to the boiling point of water, but from semiconductors and metals, which have much higher melting points. Heating the chip to such temperatures would melt not just the structures, but nearly everything else on the chip. Secondly, the melting process would widen the structures and round off their top and side surfaces, all of which would be detrimental to the chip.
Chou's team overcame the first obstacle by using a light pulse from so-called excimer laser, similar to those used in laser eye surgery, because it heats only a very thin surface layer of a material and causes no damage to the structures underneath. The researchers carefully designed the pulse so that it would melt only semiconductor and metal structures, and not damage other parts of the chip. The structures need to be melted for only a fraction of a millionth of a second, because molten metal and semiconductors can flow as easily as water and have high surface tension, which allows them to change shapes very quickly.
To overcome the second obstacle, Chou's team placed a plate on top of the melting structures to guide the flow of liquid. The plate prevents a molten structure from widening, and keeps its top flat and sides vertical, Chou said. The resulting line smoothness was far more precise than what semiconductor researchers believe to be attainable with existing technology.
One of the big surprises from this work is observed when the guiding plate is placed not in direct contact with the molten structures, but at a distance above it. In this situation, the liquid material from the structures rises up and reaches the plate by itself, causing line structures to become taller and narrower -- both highly desirable outcomes from a chip design perspective.
COMPAMED.de; Source: Princeton University