While there are already filter systems that clean ambient air, these merely capture the virus rather than destroy it. Failure to exchange the filter may result in a perforation in the used filter, which in turn can lead to a major discharge of the virus into the room. Swapping filters can also pose problems. How best to remove the spent filter and then safely dispose of it along with its virus load? UV filters are one alternative. These do destroy most of the virus, yet the process involved can often create other harmful sub-stances. In other words, they offer a partial solution at best.
At first glance, there is little to distinguish the Fraunhofer ventilator from existing systems. The process behind it, however, is completely new. "Our ventilator system fully destroys viruses and any other organic material," says Hans-Jürgen Friedrich, group manager at Fraunhofer IKTS. "The only thing left are small quantities of CO2 and hydrogen. In other words, our process really does knock out the coronavirus."
In place of the filter found in conventional ventilators, the new system uses a process of cold combustion to remove the virus. Ambient air is fed through a saline solution, which filters out the virus and any other organic particles. The cleaned air is then released back into the room. In the saline solution are two electrodes, across which a voltage is applied. At one electrode, the organic substances in the saline solution – including any viruses – are fully oxidized to form CO2, in a process also known as cold combustion; at the other, small quantities of hydrogen are produced. In a room of normal size containing a fair number of people, this would only produce a couple of hundred milliliters of CO2 and hydrogen over the course of several hours. These two gases then disperse throughout the entire air within the room.
At present, research teams are carrying out tests with unharmful substances. "For safety reasons, we don’t use the actual coronavirus for the tests," explains Dr. Katharina Schwarz, head of department at Fraunhofer ITEM. "Instead, we use surrogates with very similar properties." In tests at Fraunhofer IKTS, these surrogates were added directly to the saline solution. Researchers then analyzed the decomposition of this biological material at the electrodes and measured how much of it remained in the cleaned air discharged by the system.
In subsequent tests, the researchers will create an aerosol laden with the virus and pump this into the saline solution. Here, too, they will use less harmful surrogates. "To the best of my knowledge, there is no standardized procedure anywhere in Europe for using an airborne aerosol of a dangerous virus in order to test the effectiveness of air purification and air disinfection systems," Schwarz says.
COMPAMED-tradefair.com; Source: Fraunhofer-Gesellschaft
