Provide your contact details to the exhibitor. Optionally, you may also add a personal message.
Your name, phone number, and e-mail address are subject to the submission of personal data. Messe Düsseldorf GmbH expressly points out that for a data transmission into third countries, for which no adequacy decision of the EU-commission is on hand certifying an adequate level of protection of personal data, it is not ensured that there are appropriate safeguards for the protection of personal data on hand.
Please log in
You must be logged in to send the contact request.
An error has occurred
Please check your internet connection or try again later.
Message has been sent
Your message to the exhibitor was sent successfully.
Product category: Rapid prototyping, Metal cutting, chip removal
We can provide difficult to cut material like titanium, magnesium, tangsten, molybdenum, they are so hard materials. This mirror finish made just by machinig. We can provide grind less mirror finish and reduce cost and lead time. Also provide surface roughness is Ra 1 micron. For example, when we produce mechanical parts for injection molding, always there is grinding process, but we can cut the process thereby it reduce cost and lead time.